Tube🌞Time24 авг., 23:57i reverse-engineered the Raspberry Pi Compute Module 5! check it out at github.com/schlae/cm5-r...
Jeff Geerling25 авг., 00:03Dang it! I have the lumafield scans of the CM5, could've assisted probably. I can get them to you before I post them publicly if it'll still help your effort with any stray traces...Ответ для Jeff GeerlingTube🌞Time25 авг., 00:12i think i got them all, but that would have saved some time 😅Ещё 4 ответа
Jeff Geerling25 авг., 00:03Dang it! I have the lumafield scans of the CM5, could've assisted probably. I can get them to you before I post them publicly if it'll still help your effort with any stray traces...
Ответ для Jeff GeerlingTube🌞Time25 авг., 00:12i think i got them all, but that would have saved some time 😅Ещё 4 ответа
Tube🌞Time25 авг., 00:00how? first i removed all the parts from a bad CM5, then measured each passive component to figure out the value.Ответ для Tube🌞TimeTube🌞Time25 авг., 00:00then i scanned the now parts-free top and bottom of the board, and started wet sanding to get to the next layer.Ещё 7 ответов
Tube🌞Time25 авг., 00:00how? first i removed all the parts from a bad CM5, then measured each passive component to figure out the value.
Ответ для Tube🌞TimeTube🌞Time25 авг., 00:00then i scanned the now parts-free top and bottom of the board, and started wet sanding to get to the next layer.Ещё 7 ответов
Tube🌞Time25 авг., 00:00then i scanned the now parts-free top and bottom of the board, and started wet sanding to get to the next layer.
